J-33880 Alternative Detroit 50 and 60 Series Brass Injector Sleeve Remover & Installer Tool Set

J-33880 Alternative Detroit 50 and 60 Series Brass Injector Sleeve Remover & Installer Tool Set 

This tool kit is used to remove, install, ream and cut copper injector sleeves. Cylinder head must be removed.

For use on brass injector sleeve cups 240-1028, 240-1017, 8929078 and 23501580.

Includes aftermarket equivalents of:

• 1x J-33880-1 Injector Sleeve Nose Reamer Tool (Wear item no warranty.)
• 1x J-33880-3 Guide Sleeve Tool
• 1x J-33880-4 Injector Sleeve Remover Installer Mandrel Tool (Wear item no warranty.)
• 1x J-5286-5 Injector Sleeve Remover Installer Guide Mandrel Tool
• 1x J-33880-5 Injector Sleeve Tip Reamer Tool (Wear item no warranty.)
• 1x J-5286-6 Injector Sleeve Flaring Die (Wear item no warranty.)
• 1x J-33880-7 Injector Sleeve Precision Pilot Tool
• 1x J-5286-8 Injector Sleeve Tip Refinisher Tool (Wear item no warranty.)
• 1x J-33880-10 Injector Nose Reamer Guide Tool (Wear item no warranty.)
• 1x J-33880-20 Injector Sleeve Stop Block Gauge Tool

For stainless steel injector sleeves use the below tooling.

• Use FEPRO6904 for screw-in stainless cups 240-1039, 23538840, 240-1035 and 23533148
• Use FEPRO8824 for screw-in stainless cups 240-1045, 23534745 and 23538829

Applications:

• Detroit Diesel 50 Series
• Detroit Diesel 60 Series 11.1L with N2 Injectors
• Detroit Diesel 60 Series 12.7L with N2 Injectors
• Detroit Diesel 60 Series 14.0L with N2 Injectors